Place sliding bracket on hoop as shown. The top of the bracket must be aligned with the top of the bracket slide support and the first marked line ("A" positioning) when using extended embroidery cards, such as cards #14 and #31.
When not using the ext
Slide bracket down to the next line for the (B) positioning, Tighten the locking screws, and embroider the next flower.
Slide the bracket to the next mark, tighten the locking screws, and embroider the flower again. "C"position.
Slide the bracket to the next mark, tighten the locking screws and embroider the fern. "D" position.
Loosen locking screws and remove bracket off and place on bottom side of hoop.
You may leave the bracket on the machine by loosening the locking screws, and then slide the hoop off and replace on the bottom side, if you wish.
Slide the bracket to the next desired location. You do not need to rely on the marked lines unless you are using extended patterns. Each marked line is 3.5 cm apart from the first "A" positioning mark.
If there is no template available, try sewing the
Slide bracket to the next desired location and repeat step 6.
In most cases its o.k. to overlap embroidery designs. However, two very dense designs layered on top of each other could cause tension, needle and/or thread breakage problems. If looping of
Remove bracket off hoop and place on next side. Slide bracket to desired location. pivot design 180 degrees, trace and embroider design upside down.
Loosen locking screws and remove the sliding bracket off hoop.
Now is the time to use your own creativity. Look at other cards or design your own.
Turn the GIANT hoop so that the design is as you would naturally see it and imagine birds, butterflies,
The hummingbird in our creation has been pivoted 90 degrees. Use a template, if available so that it is facing the flower.
Move sliding bracket to the desired location. In the "EDIT MODE" of machine move bird right or left as needed. Then embroider.
Slide bracket to next location. Rotate bird to it's original position. Use edit arrows to bring more to the center of the hoop. Embroider.
Hint: Use the "Forward Search" in the HELP area of the sewing machine to eliminate portions of embroidery cards.
Slide bracket to next location, use edit keys for placement, pivot 90 degrees, trace and embroider the bee.
Slide bracket and embroider the butterfly upside down.
After removing bracket and replacing on top side, pivot bird 90 degrees, slide bracket to desired position, and embroider top bird.
When monogramming (Springtime), the number of letters that can be entered is dependent on the size and the machine's limited embroidery field.
Remember to pivot the letters 90 degrees.
Enter the number of letters you can, sew them off, then slide th
