Westalee Design launched Spin-e-fex in January 2012 and the range has been growing ever since. Spin-e-fex uses our unique Westalee Design Key System. The Key System makes it possible to stitch around the inside of a template without the need to cut the threads, to enter or exit the template and leaves no unsightly flat line when stitching past an open gate entrance.

Ruler foot is not included and must be purchased separately if you do not already own the foot

Simply provide your Brand and Model number of your sewing machine when ordering, and Sew Steady will send the correct rulers for your machine's shank style.

Ruler Thickness:
Low Shank: 3mm Ruler Thickness
High Shank 4-5mm Ruler Thickness
Longarms: 6mm Ruler Thickness

The Sew Steady Westalee Templates and Accessories are custom made to order, and usually leave the warehouse in 5-7 business days after your order is placed

Attention Bernina Owners: If you are currently using the Bernina #72 Ruler Foot, instead of the Westalee Ruler Foot, please specify that in the brand and model of machine question, or in the comments of your order, since that foot could require a different thickness of Westalee ruler.
Curly-Q Template Video. Instruction on using the Westalee Curly-Q Template for Domestic Sewing Machines
Specifications
These templates will create a variety of designs that can stand alone or be used to offset and echo a specific design.
1) Place stable tape on the underside of your template at locations that would be pressure points when holding the template in place while sewing

2) Determine the desired placement of your template design within the block

3) Place the template at the beginning point of your desired design – make note of the markings on the template that you are using to create a consistent design
a. Make sure that your needle is in the middle of the foot to insure that you are sewing ¼ inch off the template edge
b. Place the ruler foot snugly against the template and pull your bobbin thread to the top
c. Begin sewing keeping the ruler foot touching the template, and tracing around the outside edge of the template
d. Once you are at the end of the template leave the needle down and move the template, line back up on the markings you selected and repeat this pattern until the end of the design, or the end of the block

4) You may also use the dashed etched markings on the template to echo and / or offset your design (see A) by lining up the template on the stitch line you just made then use the selected etching on the template to create the echo or offset design.

Part#WT-SFXSCQSET2:
Set #2 Includes: (2 1/2”, 4 1/2”, 6 1/2”, 8 1/2”, 10 1/2”, 11 1/2” wide)

Also available: Sold as 6-pc Sets - WT-SFXSCQSET1: Set #1 (1 1/2”, 3 1/2”, 5 1/2”, 7 1/2”, 9 1/2”, 11 1/2”)

Each Template Sold Individually as well.



Included Accessories
  • Stable Tape
Andrea L, Poultney VT
This particular order took two weeks to receive, but it was coming directly from the manufacturer. No doubt current circumstances played a large part in that. Once I got it, I was delighted! I will be back for more supplies!